It was quite a process applying the texture to the walls and ceiling. The first stage was to just get the air compressor and spray gun set up. This went quite easily because I was able to purchase all of the accessories for the air compressor in the same 1/4" air outlet size. This meant I didn't have to buy any adapters to go from one size to another. However, I did hit one embarrassing snag with the spray gun. I read the instructions, which stated that some guns come with a plug in the air inlet. This is the place where you connect the air compressor hose tothe gun. Well, I found (what I thought was a plug) and proceeded to spend about 30 minutes trying to unscrew it. It was only after utilizing my vice grips and a hex wrench that I finally got it out. I then proceeded to connect the air hose into it when I found out the air hose did not fit into the hole. I could not figure it until I looked over the rest of the gun and noticed a plug that looked like it should fit into th...
This was a chronicle of my DIY journey. Here you’ll find various resources and lessons learned. Now, I this will be a place to write life lessons and reflections. Thanks for visiting my blog (and please leave a comment so that I'll know someone is actually reading this thing).